Cold Storage
Our light-weight, easy to assemble, cold storage warehouse applications have internal and external supports to ensure maximum strength and stability. We also provide sliding doors and large walk through doors to accommodate personnel and equipment.
Units are available in a variety of configurations including: remote, top mount self-contained, side mount self-contained, pre-assembled non-charged, and pre-assembled pre-charged.
- Remote System
- Mount Refrigeration
- Penthouse Refrigeration
Remote Systems
Remote systems are the least expensive systems to purchase. They consist of a condensing unit, evaporator unit and misc. parts such as expansion valve, site glass, dryer, pump down solenoid thermostat, and on freezers a timer and drain heater to install the system. They also provide an advantage by allowing the condensing unit to be located outside the building. There the condensing unit can dump its heat without adding extra heat to the building and air conditioning systems.
Pre-assembled Remote Systems
Pre-assembled Remote Systems are the same as Remote Systems except all the parts are shipped installed on either the condensing unit or the evaporator coil. Pre-assembled Remote Pre-charged systems come with the condensing unit, the evaporator coil and line set (copper pipes that connect the two units) charged with refrigeration gas.
Mount Refrigeration
Standard Top Mount
Top Mount Systems are self-contained refrigeration systems. They come with allparts, copper lines and refrigeration gases completely installed.
Side Mount Refrigeration System
Side Mount Refrigeration Systems are the same as Top Mount Refrigeration Systems except they are installed on one of the wall panels with bolts that go through the refrigeration plug and wall panel and are attached with nuts on the inside of the walk-in. They also require that a condensation drain hose be connected to a drain nearby.
Saddle Mount Refrigeration System
Saddle Mount Refrigeration Systems come completely pre-assembled on a bracket that is designed to be mounted over the top of one of the wall panels. These systems must be installed on a panel with slots cut in the top to allow the bracket to go through the wall. These systems are hung over the wall before the installation of the roof. These units also have the evaporator coil that hangs from the top of the panel but it is more toward the top and doesn't interfere with the shelving as much as a side-mount unit.
Penthouse Refrigeration
Penthouse Refrigeration System
Penthouse Refrigeration Systems are like Standard Top Mount Systems except they do not have an evaporator coil sticking down inside the walk-in. The air inside the walk-in is drawn up through the evaporator coil located with the condensing unit on top of the walk-in to be cooled.